Dell Latitude 3190 2-in-1 Owners Manual - Page 27

Installing the touchpad, Power connector port, Removing power connector port

Get Dell Latitude 3190 2-in-1 PDF manuals and user guides View all Dell Latitude 3190 2-in-1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

Installing the touchpad 1. Place the touchpad into the slot on the system. 2. Align and place touchpad bracket over the plastic hold down and replace the six M2x2 and one M2x3 screw to secure it to the system. 3. Affix the adhesive tapes to secure the touchpad bracket 4. Connect the touchpad cable to the connector and affix the adhesive-backed cable to secure it to the touchpad. 5. Install the: a) battery b) base cover 6. Follow the procedure in After working inside your computer. Power connector port Removing power connector port 1. Follow the procedure in Before working inside your computer. 2. Remove the: a) base cover b) battery 3. To remove the power connector port: a) Disconnect the power connector cable from the connector on the system board [1]. b) Remove the two M2x3 screws that secure the power connector port on the computer [2]. c) Slide and lift the power connector port from the computer [3]. Disassembly and reassembly 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
Installing the touchpad
1.
Place the touchpad into the slot on the system.
2.
Align and place touchpad bracket over the plastic hold down and replace the six M2x2 and one M2x3 screw to secure it to the system.
3.
Affix the adhesive tapes to secure the touchpad bracket
4.
Connect the touchpad cable to the connector and affix the adhesive—backed cable to secure it to the touchpad.
5.
Install the:
a)
battery
b)
base cover
6.
Follow the procedure in
After working inside your computer
.
Power connector port
Removing power connector port
1.
Follow the procedure in
Before working inside your computer
.
2.
Remove the:
a)
base cover
b)
battery
3.
To remove the power connector port:
a)
Disconnect the power connector cable from the connector on the system board [1].
b)
Remove the two M2x3 screws that secure the power connector port on the computer [2].
c)
Slide and lift the power connector port from the computer [3].
Disassembly and reassembly
27