Dell Latitude 5300 2-in-1 Chromebook Enterprise Latitude 5300 2-in-1 Chrome Se - Page 70
Open the display assembly to a 180-degree angle and flip over the system
![]() |
View all Dell Latitude 5300 2-in-1 Chromebook Enterprise manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Steps 1. Peel the adhesive tape and disconnect the EMR sensor cable from the connector on the system board [1]. 2. Peel the adhesive tape and disconnect the touch screen cable from the connector on the system board [2]. 3. Remove the single (M2x4) screw that secures the eDP cable bracket to the system board [3]. 4. Lift the eDP cable bracket from the system board [4]. 5. Disconnect the eDP cable from the system board [5]. 6. Open the display assembly to a 180-degree angle and flip over the system, and then place the system on a flat surface. 70 Removing and installing components
![](/manual_guide/products/dell-latitude-5300-2in1-chromebook-enterprise-latitude-5300-2in1-chrome-service-manual-0ac4f99/70.png)
Steps
1.
Peel the adhesive tape and disconnect the EMR sensor cable from the connector on the system board [1].
2.
Peel the adhesive tape and disconnect the touch screen cable from the connector on the system board [2].
3.
Remove the single (M2x4) screw that secures the eDP cable bracket to the system board [3].
4.
Lift the eDP cable bracket from the system board [4].
5.
Disconnect the eDP cable from the system board [5].
6.
Open the display assembly to a 180-degree angle and flip over the system, and then place the system on a flat surface.
70
Removing and installing components