Dell Latitude 5300 2-in-1 Service Manual - Page 77
Open the display assembly to a 180-degree angle and flip over the system
View all Dell Latitude 5300 2-in-1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Steps 1. Peel the adhesive tape and disconnect the cable from the connector on the system board [1]. 2. Remove the single (M2x4) screw that secures the eDP cable bracket to the system board [2]. 3. Lift the eDP cable bracket from the system board [3]. 4. Disconnect and unroute the eDP cable [4]. 5. Open the display assembly to a 180-degree angle and flip over the system, and then place the system on a flat surface. Disassembly and reassembly 77
Steps
1.
Peel the adhesive tape and disconnect the cable from the connector on the system board [1].
2.
Remove the single (M2x4) screw that secures the eDP cable bracket to the system board [2].
3.
Lift the eDP cable bracket from the system board [3].
4.
Disconnect and unroute the eDP cable [4].
5.
Open the display assembly to a 180-degree angle and flip over the system, and then place the system on a flat surface.
Disassembly and reassembly
77