Dell M2400 Service Manual - Page 25

Removing the Hinge Covers, Replacing the Hinge Covers - displayport

Get Dell M2400 - Precision Mobile Workstation PDF manuals and user guides View all Dell M2400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Removing the Hinge Covers CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer. The hinge covers are not interchangeable; the left one covers the DisplayPort connector and the right one covers the RJ-45 network connector. 1. Follow the procedures in Before Working on Your Computer. 2. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly). 3. Remove the M2.5 x 5-mm screw from each hinge cover. 4. Slide each hinge cover forward and lift to remove it. 1 M2.5 x 5-mm screws (2) 2 hinge covers Replacing the Hinge Covers 1. Slide the left hinge cover over the DisplayPort connector and slide the right hinge cover over the RJ-45 network connector. 2. Replace the M2.5x5-mm screw in each hinge cover. 3. Replace the bottom of the base assembly (see Replacing the Bottom of the Base Assembly). 4. Follow the procedures in After Working on Your Computer.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
Removing the Hinge Covers
CAUTION:
Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
The hinge covers are not interchangeable; the left one covers the DisplayPort connector and the right
one covers the RJ-45 network connector.
1.
Follow the procedures in
Before Working on Your Computer
.
2.
Remove the bottom of the base assembly (see
Removing the Bottom of the Base Assembly
).
3.
Remove the M2.5 x 5-mm screw from each hinge cover.
4.
Slide each hinge cover forward and lift to remove it.
1 M2.5 x 5-mm screws (2) 2 hinge covers
Replacing the Hinge Covers
1.
Slide the left hinge cover over the DisplayPort connector and slide the right hinge cover over
the RJ-45 network connector.
2.
Replace the M2.5x5-mm screw in each hinge cover.
3.
Replace the bottom of the base assembly (see
Replacing the Bottom of the Base Assembly
).
4.
Follow the procedures in
After Working on Your Computer
.