Dell M2400 Service Manual - Page 61

Caution, Notice

Get Dell M2400 - Precision Mobile Workstation PDF manuals and user guides View all Dell M2400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 61 highlights

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer. NOTICE: If you are installing two memory modules, you must install the bottom memory module first. 1. Place the module at a 45-degree angle, and align the notch in the module with the tab on the connector. NOTE: If the memory module is not installed properly, the computer may not boot. No error message indicates this failure. 2. Press down on the module until it clicks into place. If the module does not click into place, remove the module and reinstall it. 1 tab 2 notch 3. Replace the bottom of the base assembly (see Replacing the Bottom of the Base Assembly). 4. Follow the procedures in After Working on Your Computer. As the computer boots, it detects the additional memory and automatically updates the system configuration information. To confirm the amount of memory installed in the computer: • In Windows XP, right-click the My Computer icon on your desktop. Click Properties→€General. • In Windows Vista, click Start Information. →€Help and Support→€Dell System

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
CAUTION:
Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
NOTICE:
If you are installing two memory modules, you must install the bottom
memory module first.
1.
Place the module at a 45-degree angle, and align the notch in the module with the tab on the
connector.
NOTE:
If the memory module is not installed properly, the computer may not boot. No error
message indicates this failure.
2.
Press down on the module until it clicks into place. If the module does not click into place,
remove the module and reinstall it.
1
tab
2
notch
3.
Replace the bottom of the base assembly (see
Replacing the Bottom of the Base Assembly
).
4.
Follow the procedures in
After Working on Your Computer
.
As the computer boots, it detects the additional memory and automatically updates the system
configuration information. To confirm the amount of memory installed in the computer:
•
In Windows XP, right-click the
My Computer
icon on your desktop.
Click
Properties
→€
General
.
•
In Windows Vista, click
Start
→€
Help and Support
→€
Dell System
Information
.