Dell M2400 Service Manual - Page 31

Replacing the 1.8 Hard Drive E6400 ATG

Get Dell M2400 - Precision Mobile Workstation PDF manuals and user guides View all Dell M2400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

1 hard drive 2 blue bumper Replacing the 1.8" Hard Drive (E6400 ATG) CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer. NOTICE: Hard drives are extremely fragile. Exercise care when handling the hard drive. NOTICE: Use firm and even pressure to slide the hard drive into place. Excessive force may result in damage to the connector. NOTICE: The top and bottom of the blue bumper are different. The top is flat with slight ridges, and the bottom has protruding ridges. When replacing the blue bumper around the hard drive, ensure that the top is installed facing up, otherwise the cover will not completely close on the hard drive carrier. 1. With the top of the bumper facing up, place the end of the blue bumper on the end of the hard drive opposite from the connector, then enclose the two sides of the hard drive with the blue bumper.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
1 hard drive 2 blue bumper
Replacing the 1.8" Hard Drive (E6400 ATG)
CAUTION:
Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
NOTICE:
Hard drives are extremely fragile. Exercise care when handling the hard drive.
NOTICE:
Use firm and even pressure to slide the hard drive into place. Excessive force
may result in damage to the connector.
NOTICE:
The top and bottom of the blue bumper are different. The top is flat with slight
ridges, and the bottom has protruding ridges. When replacing the blue bumper around
the hard drive, ensure that the top is installed facing up, otherwise the cover will not
completely close on the hard drive carrier.
1.
With the top of the bumper facing up, place the end of the blue bumper on the end of the hard
drive opposite from the connector, then enclose the two sides of the hard drive with the blue
bumper.