Dell PowerConnect 3424 User's Guide (.htm) - Page 61
Initial Configuration, SNMP Community String and SNMP Management System IP address optional - easy setup wizard
View all Dell PowerConnect 3424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Initial Configuration NOTE: Before proceeding, read the release notes for this product. Download the release notes from the Dell Support website at support.dell.com. NOTE: The initial configuration assumes the following: • The PowerConnect device was never configured before and is in the same state as when you received it. • The PowerConnect device booted successfully. • The console connection is established and the console prompt is displayed on the screen of a VT100 terminal device. The initial device configuration is through the Console port. After the initial configuration, the device can be managed either from the already connected Console port or remotely through an interface defined during the initial configuration. If this is the first time the device has booted up, or if the configuration file is empty because the device has not been configured, the user is prompted to use the Setup Wizard. The Setup Wizard provides guidance through the initial device configuration, and gets the device up and running as quickly as possible. NOTE: Obtain the following information from the network administrator before configuring the device: • The IP address to be assigned to the VLAN 1 interface through which the device is to be managed (by default, every port is a member of the VLAN 1) • The IP subnet mask for the network • The default gateway (next hop router) IP address for configuring the default route. • SNMP community string and SNMP management system IP address (optional) • Username and password The Setup Wizard guides you through the initial switch configuration, and gets the system up and running as quickly as possible. You can skip the Setup Wizard, and manually configure the device through the device CLI mode. The Setup Wizard configures the following fields. • SNMP Community String and SNMP Management System IP address (optional) • Username and Password • Device IP address • Default Gateway IP address The following is displayed: Welcome to Dell Easy Setup Wizard The Setup Wizard guides you through the initial switch configuration, and gets you up and running as quickly as possible. You can skip the setup wizard, and enter CLI mode to manually configure the switch. Configuring PowerConnect 3424/P and 3448/P 61