Dell PowerConnect 3424 User's Guide (.htm) - Page 62
Wizard Step 1, Would you like to setup the SNMP management interface now?
View all Dell PowerConnect 3424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
www.dell.com | support.dell.com The system will prompt you with a default answer; by pressing enter, you accept the default. You must respond to the next question to run the setup wizard within 60 seconds, otherwise the system will continue with normal operation using the default system configuration. Would you like to enter the Setup Wizard (you must answer this question within 60 seconds? (Y/N)[Y]Y You can exit the Setup Wizard at any time by entering [ctrl+Z]. If you enter [N], the Setup Wizard exits. If there is no response within 60 seconds, the Setup Wizard automatically exits and the CLI console prompt appears. If you enter [Y], the Setup Wizard provides interactive guidance through the initial device configuration. NOTE: If there is no response within 60 seconds, and there is a BootP server on the network, an address is retrieved from the BootP server. NOTE: You can exit the Setup Wizard at any time by entering [ctrl+z]. Wizard Step 1 The following is displayed: The system is not setup for SNMP management by default. To manage the switch using SNMP (required for Dell Network Manager) you can • Setup the initial SNMP version 2 account now. • Return later and setup additional SNMP v1/v3 accounts. For more information on setting up SNMP accounts, please see the user documentation. Would you like to setup the SNMP management interface now? (Y/N)[Y]Y Enter [N] to skip to Step 2. Enter [Y] to continue the Setup Wizard. The following is displayed: To setup the SNMP management account you must specify the management system IP address and the "community string" or password that the particular management system uses to access the switch. The wizard automatically assigns the highest access level [Privilege Level 15] to this account. You can use Dell Network Manager or CLI to change this setting, and to add additional management systems. For more information on adding management systems, see the user documentation. To add a management station: 62 Configuring PowerConnect 3424/P and 3448/P