Dell PowerConnect W Clearpass 100 Software HP ProCurve MSM Integration Guide - Page 12

HP ProCurve MSM Configuration

Get Dell PowerConnect W Clearpass 100 Software PDF manuals and user guides View all Dell PowerConnect W Clearpass 100 Software manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

HP ProCurve MSM Configuration The following configuration procedure assumes that the HP ProCurve MSM710 has been powered up and a basic IP configuration has been applied through the steps detailed in the Getting Started Chapter of the HP ProCurve Admin Guide. The following table again reviews the IP Addressing used in the test environment but this would be replaced with the site specific details of each customer deployment: MSM710 IP Address Internet Gateway Address amigopod IP Address amigopod RADIUS port 10.0.20.25 10.0.20.1 10.0.20.60 Auth 1812 Acc 1813 (default settings) Depending on your network design the MSM710 may need to be configured to perform Network Address Translation (NAT) on the Internet port. As can be seen from the previous Lab Topology diagram, to simplify our lab routing environment NAT has been enabled. If NAT is required in your network design, the MSM NAT settings can be found under Service ControllerNetworkInternet Port as shown below: CONFIDENTIAL 12

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
CONFIDENTIAL
12
HP ProCurve MSM Configuration
The following configuration procedure assumes that the HP ProCurve MSM710 has been
powered up and a basic IP configuration has been applied through the steps detailed in the
Getting Started Chapter of the HP ProCurve Admin Guide. The following table again reviews the
IP Addressing used in the test environment but this would be replaced with the site specific
details of each customer deployment:
MSM710 IP Address
10.0.20.25
Internet Gateway Address
10.0.20.1
amigopod IP Address
10.0.20.60
amigopod RADIUS port
Auth 1812
Acc 1813 (default settings)
Depending on your network design the MSM710 may need to be configured to perform Network
Address Translation (NAT) on the
Internet
port. As can be seen from the previous Lab Topology
diagram, to simplify our lab routing environment NAT has been enabled.
If NAT is required in your network design, the MSM NAT settings can be found under
Service
Controller
Network
Internet Port
as shown below: