Dell PowerConnect W Clearpass 100 Software HP ProCurve MSM Integration Guide - Page 20

Step 6 - Con the Default VSC

Get Dell PowerConnect W Clearpass 100 Software PDF manuals and user guides View all Dell PowerConnect W Clearpass 100 Software manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

Step 6 - Configure the Default VSC A Virtual Service Community is defined by HP ProCurve as a collection of configuration settings that define key operating characteristics of the service controller and controlled APs. In most cases. A VSC is used to define the characteristics of a wireless network. The VSC configuration can be accessed from the left hand pane of the Management Tool by clicking on the + sign next to the Service Controller option. You will then be able to see the default VSC available on the controller. As you can see from the default settings shown below, both the VSC name and SSID for the wireless is set to HP ProCurve. Obviously if the MSM is being used to control wired traffic only access then the SSID is of little interest. There are several other configuration settings within the VSC that are critical to the functioning of this Guest access design. To make these changes enter into the default VSC configuration by clicking on the HP ProCurve option below the VSC container. CONFIDENTIAL 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
CONFIDENTIAL
20
Step 6 – Configure the Default VSC
A Virtual Service Community is defined by HP ProCurve as a collection of configuration settings
that define key operating characteristics of the service controller and controlled APs. In most
cases. A VSC is used to define the characteristics of a wireless network.
The VSC configuration can be accessed from the left hand pane of the Management Tool by
clicking on the + sign next to the
Service Controller
option. You will then be able to see the
default VSC available on the controller.
As you can see from the default settings shown below, both the VSC name and SSID for the
wireless is set to
HP ProCurve
. Obviously if the MSM is being used to control wired traffic only
access then the SSID is of little interest.
There are several other configuration settings within the VSC that are critical to the functioning
of this Guest access design. To make these changes enter into the default VSC configuration by
clicking on the
HP ProCurve
option below the VSC container.