Dell PowerEdge 1900 Hardware Owner's Manual (PDF) - Page 117
Troubleshooting Expansion Cards - battery
View all Dell PowerEdge 1900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
9 If you have a SAS RAID controller daughter card, ensure that the following RAID components are properly installed and connected: • Memory module • Battery 10 Verify that the cable connections between the hard drive(s) and the SAS controller card or SAS RAID controller daughter card are correct. See Figure 3-13 (SAS controller card) or Figure 3-14 (SAS RAID controller daughter card). 11 Verify that the SAS or SATA cables are securely seated in their connectors. 12 Verify that the hard drive LED activity indicator cable is correctly installed. See Figure 3-13 (SAS controller card) or Figure 3-14 (SAS RAID controller daughter card). 13 Close the system. See "Closing the System" on page 48. 14 Reconnect the system to its electrical outlet, and turn on the system and attached peripherals. If the problem persists, proceed as follows: • If you have a SAS controller card, see "Getting Help" on page 131. • If you have a SAS RAID controller daughter card, replace the SAS RAID daughter card battery. See "Replacing the SAS RAID Controller Daughter Card Battery" on page 92. If replacing the battery does not solve the problem, see "Getting Help" on page 131. Troubleshooting Expansion Cards NOTE: When troubleshooting an expansion card, see the documentation for your operating system and the expansion card. Problem • Error message indicates a problem with an expansion card. • Expansion card performs incorrectly or not at all. Action CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer and protecting against electrostatic discharge. 1 Run the appropriate online diagnostic test. See "Using Server Administrator Diagnostics" on page 121. 2 Open or remove the bezel. See "Removing the Bezel" on page 46. 3 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 4 Open the system. See "Opening the System" on page 48. 5 Ensure that each expansion card is firmly seated in its connector. See "Installing an Expansion Card" on page 57. Troubleshooting Your System 117