Dell PowerEdge 1900 Hardware Owner's Manual (PDF) - Page 93
Removing the SAS RAID Controller Daughter Card, If applicable - replace hard drive
View all Dell PowerEdge 1900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Figure 3-25. Replacing a SAS RAID Controller Daughter Card Battery 8 9 1 7 2 6 5 4 3 1 connector release tab 2 routing hole for RAID battery 3 RAID battery cable cable 4 expansion-bay bracket 5 battery bay 6 RAID battery 7 SAS RAID controller daughter 8 hard drive LED activity cable 9 hard drive LED activity cable card connector Removing the SAS RAID Controller Daughter Card 1 If applicable, disconnect the RAID battery cable from the controller card by releasing the tab on the cable connector on the SAS RAID controller daughter card and disconnecting the battery cable. See Figure 3-26. 2 Remove the hard drive LED activity cable from the SAS RAID controller daughter card. 3 Push outward on the plastic guide rails and gently pull up on the card edges until the card-edge connector clears the socket on the system board. See Figure 3-26. Installing System Components 93