Dell PowerEdge 4350 Dell PowerEdge 4350 Systems Service Manual - Page 65
the drive bracket. First disconnect the interposer cable from the drive. Then
View all Dell PowerEdge 4350 manuals
Add to My Manuals
Save this manual to your list of manuals |
Removing and Replacing Parts
4-9
The replacement drive and bracket come preassembled.To install the assem-
bly into the diskette drive slot, follow these steps:
1.
Position the flat side of the diskette drive bracket against the left wall of the
diskette drive slot (make sure the control-panel ribbon cable is placed to
the right of the drive assembly).
2.
Slide the assembly into the chassis with the bracket flat against the slot
wall.
When the assembly is about 2 inches into the chassis, the edges of the
bracket should start engaging the slide tracks on the slot wall. If the bracket
does not engage the tracks, remove the assembly and try again.
If you want to store the drive you removed as a separate part, remove it from
the drive bracket. First disconnect the interposer cable from the drive. Then
press down on the bracket latch to release the drive, and pull the drive away
from the bracket.
When reinstalling the stored drive to the drive bracket and reconnecting the
interposer cable, be sure to note the orientation of the interposer cableĀ³s con-
tacts. The contact side of the cable must be positioned toward the diskette
drive bracket (see Figure 4-6).