Dell PowerEdge 4350 Dell PowerEdge 4350 Systems Service Manual - Page 85
side of the system board to release the bracket, and pull the bracket away
View all Dell PowerEdge 4350 manuals
Add to My Manuals
Save this manual to your list of manuals |
Removing and Replacing Parts
4-29
*XLGH±%UDFNHW±$VVHPEO\
)LJXUH±·´µµ³±±*XLGH´%UDFNHW±$VVHPEO\±5HPRYDO±
To remove the guide bracket assembly, follow these steps:
1.
Remove the system board.
2.
Remove terminator cartridge and SEC cartridge/heat sink assemblies if
necessary.
3.
From the topside of the system board, use a flat-blade screwdriver to
remove the screws at each end of the bracket(s) (see Figure 4-22).
4.
For each guide bracket, squeeze the bracket retaining tabs on the under-
side of the system board to release the bracket, and pull the bracket away
from the system board.
screws (2)
guide bracket