Dell PowerEdge 4350 Dell PowerEdge 4350 Systems Service Manual - Page 83

If you are migrating components such as expansion cards, SEC cartridge

Get Dell PowerEdge 4350 PDF manuals and user guides View all Dell PowerEdge 4350 manuals
Add to My Manuals
Save this manual to your list of manuals
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
Removing and Replacing Parts
4-27
6\VWHP±%RDUG
)LJXUH±·´µ²³±±6\VWHP´%RDUG±5HPRYDO
To remove the system board from the chassis, perform the following steps:
1.
Remove the system fan assembly.
2.
Remove the center brace.
The center brace is secured by two screws on the right side of the chassis
and one screw on the left, and both ends of the brace are hooked into the
chassis walls. Remove the screws and work the brace up out of the
chassis (see Figure 4-21).
3.
Disconnect all cables from the system board.
Be sure to record where each cable is attached.
4.
If you are migrating components (such as expansion cards, SEC cartridge/
heat sink assemblies, or guide bracket assemblies) to a replacement sys-
tem board, remove those components now.
Note the slot numbers of any PCI cards you are migrating to the new
system board so that you can install them in the same slots on the new
board.
system board
thumbscrew
center brace
system fan assembly
center-brace screws (3)