Dell PowerEdge XE2420 EMC Technical Specifications - Page 15

Drive specifications Drives The PowerEdge XE2420 system supports the following drive configurations: Table 13. Supported drives Configuration 1A 2C 3A Number of drives up to 2 x 2.5-inch up to 4 x 2.5-inch up to 6 x SSDs Drive types SATA/NVME SATA/NVME/SAS Enterprise and Data Center SSD Form Factor (EDSFF) NOTE: In 2C configuration, hard drive slots 2 and 3 do not support NVMe drives if only one processor is installed. NOTE: For more information about how to hot swap NVMe PCIe SSD U.2 device, see the Dell Expres> Browse all Products > Data Center Infrastructure > Storage Adapters & Controllers > Dell PowerEdge Express Flash NVMe PCIe SSD > Documentation > Manuals and Documentss Flash NVMe PCIe SSD User's Guide at https://www.dell.com/ support. Ports and connectors specifications USB ports specifications Table 14. PowerEdge XE2420 system USB specifications Front Rear USB port type No. of ports USB port type No. of ports USB 3.0-compliant Two N/A N/A port Micro USB 2.0- One compliant port for iDRAC Direct Internal USB port type No. of ports Internal USB 3.0- One compliant port NOTE: The micro USB 2.0 compliant port can only be used as an iDRAC Direct or a management port. NIC ports specifications The PowerEdge XE2420 system supports up to two 1 Gb LAN on motherboard with 10/100/1000 Mbps Network Interface Controller (NIC) ports that are located on the front panel. The system also supports LAN on Motherboard (LOM) on an optional riser card. Serial connector specifications The PowerEdge XE2420 system supports one serial connector on the front panel, which is a 9-pin connector, Data Terminal Equipment (DTE), 16550-compliant. VGA ports specifications The PowerEdge XE2420 system supports one 15-pin VGA ports on the front panel. Technical specifications 15