Dell PowerStore 1200T EMC PowerStore Installation and Service Guide for PowerS - Page 114
Transfer parts from the faulted node to the replacement node, Install the top cover on the node
View all Dell PowerStore 1200T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Figure 136. Removing the top cover Transfer parts from the faulted node to the replacement node Transfer the following components from the faulted node to the corresponding locations in the replacement node. To help ensure the correct placement in the enclosure, transfer only one component at a time. NOTE: Confirm that all parts are fully seated before inserting the node into the base enclosure. NOTE: Do not add any components while the node is powering on. ● Transfer the power supply. ● Transfer the I/O modules and fillers. ● Transfer the embedded module without removing the 4-port card. ● Transfer the internal M.2 boot modules without removing them from the adapters. ● Transfer DIMMs. NOTE: Move DIMMs one at a time from the faulted node to the same slot on the replacement node. ● Transfer internal fans. ● Transfer the internal battery backup module. Install the top cover on the node Steps 1. Position the top cover over the node and align it with the slots in the sides at the rear of the node. 114 Base enclosure service procedures