Dell PowerStore 1200T EMC PowerStore Installation and Service Guide for PowerS - Page 154
Replace an Access Module in an NVMe expansion enclosure
View all Dell PowerStore 1200T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
Replace an Access Module in an NVMe expansion enclosure Take the following actions to remove the faulted Access Module from the NVMe expansion enclosure and install a replacement Access Module. Identify a faulted Access Module from PowerStore Manager Before you replace an Access Module, ensure that you have identified its location within the system. Using PowerStore Manager, you can identify and locate a faulted Access Module. Steps 1. From PowerStore Manager, select Hardware. 2. Select the appliance that contains the Access Module that you need to replace. 3. On the Components card, under Rear View, expand ExpansionEnclosure. 4. Select the relevant Access Module. Faulted parts appear in red in the image of the system, and report a status of Faulted in the State field. Remove an Access Module Steps 1. Label and remove the cables from the Access Module. 2. Press both orange buttons to release the Access Module latches. 1 B 2 1 A 2 Figure 181. Releasing the Access Module 3. Pull the latches to remove the Access Module from the chassis. 154 NVMe expansion enclosure service procedures