Dell PowerStore 3200T EMC PowerStore Installation and Service Guide for PowerS - Page 63
Power down the node, Remove a faulted embedded module, Table 4. Embedded module LEDs continued
View all Dell PowerStore 3200T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Table 4. Embedded module LEDs (continued) LED Location Node power Node fault Port link Ethernet port activity Ethernet port link Embedded module fault State Off Green Green blinking Off Amber Blue Amber or blue blinking Blue and amber alternating (green for 3 seconds) Blue and amber alternating at one second intervals Green Amber Off Amber blinking Off Green Off Amber Off Description Safe to remove the node when the node has been properly prepared. Node is on (main power). Node is initializing a serial over LAN session. Node is off. Fault has occurred. Node in Degraded Mode. System is booting. System uninitialized. A management IP address has not been assigned. Node in Service Mode. Link up with high speed. Link up with degraded speed. Link down. Port activity. No port activity. Link established. No link established. Embedded module has faulted. No fault has occurred, normal operation. Power down the node Power down the node as described in Power control procedures. Remove a faulted embedded module Steps 1. Label and disconnect all cables that are attached to the embedded module. CAUTION: Do not pull the node from the base enclosure. Pulling the node from the base enclosure disrupts the system cache. 2. Push the orange tab on the embedded module to release the lever. Base enclosure service procedures 63