Dell PowerVault NX3500 Hardware Owner's Manual - Page 46
Warning! No micro, A High Output power supply
View all Dell PowerVault NX3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Table 1-4. System Messages (continued) Message Causes Corrective Actions Warning: Control Panel is not installed. The control panel is not Install the control panel, or installed or has a faulty cable check the cable connections connection. between the display module, the control panel board, and the system board. See "Control Panel Assembly" on page 81. Warning! No micro Micro code update failed. code update loaded for processor n. Update the BIOS firmware. See "Getting Help" on page 113. Warning! Power The system configuration of If any system components required exceeds processor, memory modules, were just upgraded, return PSU wattage. and expansion cards may not the system to the previous Check PSU and be supported by the power configuration. If the system system supplies. boots without this warning, configuration. then the replaced Warning! Performance degraded. CPU and memory set to minimum frequencies to meet PSU wattage. System will component(s) are not supported with this power supply. If Energy Smart power supplies are installed, replace them with the High Output power supplies to use the components. See "Power Supplies" on page 77. reboot. Warning! PSU mismatch. PSU redundancy lost. Check PSU. A High Output power supply Install two High Output or and an Energy Smart power two Energy Smart power supply are installed in the supplies in the system. system at the same time. You can also run the system on one power supply until you can obtain two power supplies of the same type. See "Troubleshooting Power Supply" on page 96. 46 About Your Solution