Dell S5148F-ON EMC Networking OS10 Enterprise Edition Switch Configuration Gui - Page 36
Switch validation
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
8 Switch validation After switches are configured and devices are connected, the switch CLI is used to validate the network configuration. This section provides a list of the most common commands and their output for the examples used in this guide. 8.1 General validation commands The commands and output shown below are for S5148F-Leaf1A in the dual switch with VLT topology. The output of its peer, S5148F-Leaf1B, is similar. If the dual switch without VLT or single switch topology is used, notes are added where differences exist. Note: For additional commands and output related to the leaf-spine portion of the topology, such as BGP and Uplink Failure Detection (UFD), see Dell EMC Networking Layer 3 Leaf-Spine Deployment and Best Practices with OS10EE. 8.1.1 show interface status The show interface status | grep up command is used to verify required interfaces are up, and links are established at their appropriate speeds. S5148F-Leaf1A#show interface status | grep up Port Description Status Speed Eth 1/1/9 JumpBox_DNS up 10G Eth 1/1/17 Node1_Port1 up 25G Eth 1/1/18 Node2_Port1 up 25G Eth 1/1/19 Node3_Port1 up 25G Eth 1/1/20 Node4_Port1 up 25G Eth 1/1/53 VLTi up 100G Eth 1/1/54 VLTi up 100G Duplex full full full full full full full Mode Vlan Tagged-Vlans A 1611 T 1611 1612-1615 T 1611 1612-1615 T 1611 1612-1615 T 1611 1612-1615 - Note: For the dual switch without VLT topology, the output is identical to the above except for the description of ports 1/1/53-54. For the single switch topology, the output includes all eight node ports, and ports 1/1/53-54 are not used. 8.1.2 show port-channel summary The show port-channel summary command is used to view port channel numbers, interfaces used, and status. In OS10EE, the VLTi is automatically configured as a static LAG using port channel 1000. Ports 1/1/53 and 1/1/54 are port channel members and (P) indicates each is up and active. S5148F-Leaf1A#show port-channel summary Flags: D - Down I - member up but inactive P - member up and active U - Up (port-channel) F - Fallback Activated Group Port-Channel Type Protocol Member Ports 1000 port-channel1000 Eth STATIC 1/1/53(P) 1/1/54(P) 36 Dell EMC Networking OS10 Enterprise Edition Switch Configuration Guide for VxRail featuring S5248F-ON, S5232F-ON and S5148F-ON