Dell Vostro 5625 Service Manual - Page 46

Installing the speakers

Get Dell Vostro 5625 PDF manuals and user guides View all Dell Vostro 5625 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

Steps 1. Release the latch of the keyboard backlit connector on the system board and disconnect the keyboard backlit cable. 2. Release the latch of the keyboard connector on the system board and disconnect the keyboard cable. 3. Release the latch of the touchpad connector on the system board and disconnect the touchpad cable. 4. Remove the speakers cable from the routing guides on the palm-rest and keyboard assembly. 5. Disconnect the speaker cable. 6. Lift the speakers along with their cables off the palm-rest and keyboard assembly. Installing the speakers Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task NOTE: If either the system board or the heat sink is replaced, use the thermal grease provided in the kit to ensure that thermal conductivity is achieved. The following image(s) indicate the location of the speakers and provides a visual representation of the installation procedure. 46 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
Steps
1.
Release the latch of the keyboard backlit connector on the system board and disconnect the keyboard backlit cable.
2.
Release the latch of the keyboard connector on the system board and disconnect the keyboard cable.
3.
Release the latch of the touchpad connector on the system board and disconnect the touchpad cable.
4.
Remove the speakers cable from the routing guides on the palm-rest and keyboard assembly.
5.
Disconnect the speaker cable.
6.
Lift the speakers along with their cables off the palm-rest and keyboard assembly.
Installing the speakers
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
If either the system board or the heat sink is replaced, use the thermal grease provided in the kit to ensure that
thermal conductivity is achieved.
The following image(s) indicate the location of the speakers and provides a visual representation of the installation procedure.
46
Removing and installing components