Dell W-Series 207 Instant 6.4.3.1-4.2 User Guide - Page 177
In the CLI, Configuring 802.1X Authentication for Wired Profiles, In the Instant UI
View all Dell W-Series 207 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
In the CLI To configure 802.1X authentication for a wireless network: (Instant AP)(config)# wlan ssid-profile (Instant AP)(SSID Profile )# type {|} (Instant AP)(SSID Profile )# opmode {wpa2-aes|wpa-tkip|wpa-tkip,wpa2-aes|dynamic-wep} (Instant AP)(SSID Profile )# leap-use-session-key (Instant AP)(SSID Profile )# termination (Instant AP)(SSID Profile )# auth-server (Instant AP)(SSID Profile )# auth-server (Instant AP)(SSID Profile )# radius-reauth-interval (Instant AP)(SSID Profile )# auth-survivability (Instant AP)(SSID Profile )# exit (Instant AP)(config)# auth-survivability cache-time-out (Instant AP)(config)# end (Instant AP)# commit apply Configuring 802.1X Authentication for Wired Profiles You can configure 802.1X authentication for a wired profile in the Instant UI or CLI. In the Instant UI To enable 802.1X authentication for a wired profile: 1. Click the Wired link under More at the top right corner of the main window. The Wired window is displayed. 2. Click New under Wired Networks to create a new network or select an existing profile for which you want to enable 802.1X authentication and then click Edit. 3. In the New Wired Network or the Edit Wired Network window, ensure that all the required Wired and VLAN attributes are defined, and then click Next. 4. On the Security tab, select Enabled from the 802.1X authentication drop-down list. 5. Specify the type of authentication server to use and configure other required parameters. For more information on configuration parameters, see Configuring Security Settings for a Wired Profile on page 121. 6. Click Next to define access rules, and then click Finish to apply the changes. 7. Assign the profile to an Ethernet port. For more information, see Assigning a Profile to Ethernet Ports on page 124. In the CLI To enable 802.1X authentication for a wired profile: (Instant AP) (config)# wired-port-profile (Instant AP) (wired ap profile )# type { |} (Instant AP) (wired ap profile )# dot1x (Instant AP) (wired ap profile )# auth-server (Instant AP) (wired ap profile )# auth-server (Instant AP) (wired ap profile )# server-load-balancing (Instant AP) (wired ap profile )# radius-reauth-interval (Instant AP) (wired ap profile )# end (Instant AP)# commit apply Configuring MAC Authentication for a Network Profile MAC authentication can be used alone or it can be combined with other forms of authentication such as WEP authentication. However, it is recommended that you do not use the MAC-based authentication. This section describes the following procedures: 177 | Authentication and User Management Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide