Denon AVR 689 Owners Manual - English - Page 36

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications ENGLISH Parameter Symbols used to indicate buttons in this manual Button located on both the main unit and the remote control unit BUTTON Button only on the main unit Button only on the remote control unit [BUTTON] MULTEQ ui [Front] RESTORER uiop [DYNAMIC VOLUME] op [NIGHT] MULTEQ RESTORER [Rear] [CINEMA] [MUSIC] uiop [STD] [PARA] Adjusting the parameters 1 Press or [PARA]. Parameter is displayed. 2 Use ui to select which parameters to adjust. Only those parameters which can be adjusted under the current playback status are displayed. 3 Use o p to adjust the parameters. Repeat steps 2 and 3 to set each parameter. n To exit adjustment • Press or [PARA] during adjustment. • If no adjustment is made for a period of about 5 seconds, the adjustments made up that point are registered and the AVR-689 returns to the original mode. Surround Parameter Adjust surround sound parameters. The parameters (items) which can be adjusted differ depending upon the following conditions. • Whether an input signal is present (when playing) or not (when stopped, etc.). • The type of input signal • The type of surround mode For details of which parameters can be adjusted in each surround mode, see "Surround Modes and Parameters" (vpage 57, 58). a Mode s Cinema EQ d D. Comp (Dynamic Range Compression) f LFE g Center Image h Panorama j Dimension k Center Width l Delay Time A0 Effect Level A1 Room Size A2 SB CH OUT A3 SW ATT (Subwoofer Attenuation) A4 Subwoofer A5 Tone Control A6 Bass A7 Treble A8 MultEQ A9 Dynamic EQ S0 Dynamic Volume S1 DV Setting (Dynamic Volume Setting) S2 RESTORER S3 Night Mode S4 Default