Denon AVR 689 Owners Manual - English - Page 66

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications ENGLISH GRemote Control UnitH Symptom Cause Countermeasure Set does not work • Batteries are worn. • Replace with new batteries. properly when • You are operating outside of the • Operate within the specified remote control specified range. range. unit operated. • Obstacle between main unit and • Remove the obstacle. remote control unit. • The batteries are not inserted in • Insert the batteries in the the proper direction, as indicated proper direction, following the by the polarity marks in the polarity marks in the battery battery compartment. compartment. • The set's remote control sensor • Move the set to a place in which is exposed to strong light (direct the remote control sensor will sunlight, inverter type fluorescent not be exposed to strong light. bulb light, etc.). • The remote ID of the main unit • Set "Remote ID" for the main and remote control unit do not unit to "1". match. • The SOURCE CONTROL switches • Set the SOURCE CONTROL are not set in the correct switches to the correct positions positions. according the operation you are applying. Page 3 3 3 3 3 30 40, 42, 43, 47 ~ 50 GAudioH Symptom Cause Countermeasure No sound is • You are playing a monaural • The mode is set to something produced from source (TV, AM radio broadcast, other than "STANDARD" (Dolby/ center speaker. etc.) in the "STANDARD" (Dolby/ DTS Surround). DTS Surround) mode. No sound • The surround mode is set to • Set to a surround playback is produced "STEREO" or "DIRECT". mode. from surround speakers. No sound is • Select item other than "7.1ch" by • Select "7.1ch". produced from "Amp Assign" setting. surround back • Surround back speaker setting is • Set to something other than speaker. set to "None". "None". • The "Parameter" - "Surround • Please set "Parameter" - Parameter" - "SB CH OUT" "Surround Parameter" - "SB settings are "OFF". CH OUT" to settings other than "OFF". • Surround mode not set to a mode • Select a surround playback for 6.1- or 7.1-channel playback. mode. No sound is • Subwoofer's power not turned • Turn on the subwoofer's power. produced from on. subwoofer. • The "Subwoofer" setting at • Set to "Yes". "Speaker Setup" is set to "No". • The subwoofer is not properly • Check the connections. connected. • The subwoofer's volume is • Adjust the subwoofer's volume turned off. to an appropriate level. No test tones are • Surround mode not set to • Set to the "STANDARD"(Dolby/ produced when " S TA N D A R D " ( D o l b y / D T S DTS Surround) mode. remote control Surround). unit's TEST button is pressed. DTS sound is not • DVD player's audio output setting • Set the DVD player. For details, output. is not set to bitstream. refer to the DVD player's operating instructions. • DVD player is not compatible • Use a DTS-compatible player. with DTS sound playback. • The AVR-689's "Input Mode" • Set to the "Auto" or "DTS" setting is set to other than mode. "DTS". Page 31 32 28 23 35 31, 32 - 23 9 45 31 - - 39 63