Denon S-301 Owners Manual - Page 7

Getting Started 2 Speaker stand installation • When mounting the speaker system (SCS301) on a speaker stand or wall bracket. As shown in the diagram, fasten the speaker stand to the back of the speaker using the two included screws. When mounting, be sure to install properly and securely. • When placing the included SC-S301 speakers on a rack or shelf, fasten the included speaker stand securely using the screws included with the SC-S301 speakers (left and right). SC-S301 Screws Speaker stand SC-S301 Wall NOTE: • To ensure safety, do not place any objects on top or lean objects against the speaker system. • The speaker may topple down or fall if force is applied to the sides. Be particularly careful to avoid this, as this could cause injury or other serious accidents. • When installing the speaker systems on the wall, to ensure safety, have specialists do the installation work. • Be sure to fasten the speaker cords to a wall, etc., to prevent people from tripping over them or otherwise pulling on them accidentally, causing the speaker systems to fall. • Be sure to check for safety after installing the speaker systems. Afterwards, perform safety inspections at regular intervals to be sure there is no danger that the speaker systems will fall. DENON will accept no responsibility for damages or accidents caused by inappropriate choice of the place of installation or improper installation procedures. • For your safety, do not put anything nor lean yourself on the loudspeakers. • Do not push the loudspeaker from aside to protect it from toppling that may cause serious accident. • Fix speaker cables to prevent being caught on it and making loudspeakers toppling down. Screws Wall bracket Cautions on handling ENGLISH Getting Started DVD Surround receiver Speaker system • Switching the input function when input terminals are not connected. A clicking noise may be produced if the input function is switched when nothing is connected to the input terminals. If this happens, either turn down the VOLUME control knob or connect components to the input terminals. • Muting of HEADPHONE jack and SPEAKER terminals. The HEADPHONE jack and SPEAKER terminals include a muting circuit. Because of this, the output signals are greatly reduced for several seconds after the power switch is turned on or input function, surround mode or any other-set-up is changed. If the volume is turned up during this time, the output will be very high after the muting circuit stops functioning. Always wait until the muting circuit turns off before adjusting the volume. • Whenever the power switch is in the STANDBY state, the apparatus is still connected on AC line voltage. Please be sure to unplug the cord when you leave home for, say, a vacation. • Magnetic force of speaker system. Note that color blotching may occur on a TV, etc., due to interaction with the speaker system if there is a magnet or an object generating magnetic force nearby. Example: (a) When there are magnets on the door of the rack, stand, etc. (b) When a health device, etc., equipped with magnets is placed nearby. (c) When toys or other objects using magnets are placed nearby. Subwoofer • Muting of after power is turned ON. The built-in amplifier of the active subwoofer includes a muting circuit. The output signal is strongly attenuated for several seconds after the power is turned on. If the volume is adjusted during this time, the output may be extremely high when the muting circuit is deactivated. Be sure to wait for the muting circuit to be deactivated before adjusting the volume. NOTE: • Be sure to fasten the power supply cord to a wall, etc., to prevent people from tripping over it or otherwise pulling on it accidentally, causing the subwoofer to fall. 4 ENGLISH