Dewalt DCGG571M1 Instruction Manual - Page 21
TROUBLESHOOTING, Problem, Possible Cause, Possible Solution
View all Dewalt DCGG571M1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
English TROUBLESHOOTING Problem Unable to pull back rod Unable to push rod forward No grease when trigger is pulled Grease appears in relief valve Motor does not run when trigger is pulled Grease leaks out of the back of the grease tube Possible Cause Vacuum build up Pressure build up Rod is still connected to plunger Grease tube is empty Air pockets in the grease tube Check valve is clogged Filter is clogged Zerk fitting is blocked Battery Rubber seal is flipped the wrong direction Possible Solution Unscrew the purge valve to release vacuum. Unscrew the purge valve to release pressure. Rotate grease tube handle 90 degrees to disengage it. Add grease. Refer to Purging Air Pockets. Refer to Cleaning Contamination from the Check Valve. Refer to Cleaning Contamination from the Filter. Disconnect coupler from fitting, clean zerk fitting and grease path. Make sure the battery is fully charged. Refer to Preparing the Grease Gun for Suction and Filler Pump Filling. 19