Dewalt DW0330S Instruction Manual - Page 21
Measuring an Angle, Using the Tool as a Level
View all Dewalt DW0330S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
4. Select a a as the measurement type. • Press to display the Main Menu (Figure E 2 ). • Press to select . • Press to display the Measurement Type Menu (Figure E 3 ). • Press the arrow buttons to select a a (Figure E 4 ). • Press . 5. Determine the distance between each stud, for example, 12". Measuring an Angle E If you need to determine the angle at which something is positioned, use the tool to measure that angle (Figure W ). 1. Point the tool's laser (Figure A 1 ) toward a wall or object, and not toward anyone's eyes. 2. Press (Figure A 3 ) to turn the tool on and display the red laser dot. 3. Make sure the tool position setting (Figure C 4 ) is correct for taking the measurement. 6. Press and until the top number on the screen is set to the distance from the right edge of one stud to the left edge of the next (e.g., 12") (Figure U 1 ). 7. Line up the back of the tool with the right edge of the last stud that is nailed in (Figure U 2 ). 8. Press to start measuring the distance as you slowly move the tool to the right. 9. Continue moving the tool to the right until the bottom number on the screen is 0.00 in (Figure U 3 ). 10. Press to stop measuring. 4. Select as the measurement type. • Press to display the Main Menu (Figure E 2 ). • Press to select . • Press to display the Measurement Type Menu (Figure E 3 ). • Press the arrow buttons to select . • Press . 5. Position the tool at the angle to be measured (Figure W 1 ). 6. Press to take the measurement. 7. View the angle measurement on the screen (Figure W 2 ). 11. Using a pencil, mark the location where the left edge of the stud should be nailed into the wall frame. 12. Nail the left edge of the stud at the marked location. Using the Tool as a Level 1. Point the tool's laser (Figure A 1 ) toward a wall or object, and not toward anyone's eyes. 13. For each remaining stud in the wall frame, repeat steps 7-12 (Figure U 4 ). 2. Press (Figure A 3 ) to turn the tool on and display the red laser dot. 21