Dewalt DW0330S Instruction Manual - Page 25
Error Codes
View all Dewalt DW0330S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Error Codes E If INFO appears on the screen with a Code number, perform the corresponding Corrective Action. Code Description Corrective Action 101 Received Signal Too Weak, Use the target plate or change the target surface. Measuring Time Too Long 102 Received Signal Too High Target is too reflective. Use the target plate or change the target surface. 201 Too Much Background Light Reduce the background light on the target area. 202 Laser Beam Interrupted Remove the obstacle and repeat the measurement. 301 Temperature Too High 302 Temperature Too Low 401 Hardware Error 402 Unknown Error 500 Data Error Allow the device to cool down to a temperature within the specified Operating Temperature Range. Allow the device to warm up to a temperature within the specified Operating Temperature Range. Switch the device on/off several times. If the error still occurs, return the defective device to the Service Center or distributor. Refer to the Warranty. Contact the Service Center or distributor. Refer to the Warranty. Contact the Service Center or distributor. Refer to the Warranty. 25