Electrolux E42BS75EPS Owners Guide - Page 14
Replacing the light bulbs.
UPC - 012505691669
View all Electrolux E42BS75EPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions Replacing the light bulbs. Setting the controls to OFF does not remove power to the light circuit. (appearance may vary) Refrigerator Compartment-Upper Light Raise the grille panel, set the master power switch to the O (off) position and allow lamps to cool. To remove the light shield, press on the Left side of the shield and pull down. Replace the bulbs with appliance bulbs of the same or lower wattage. Replace the shield by engaging the bottom tab into the slot and applying light forward pressure until the shield snaps in place. Set the master power switch to the I (on) position and close the grille panel. Refrigerator Compartment-Lower Light This light is located above the top drawer. Raise the grille panel, set the master power switch to the O (off) position and allow lamps to cool. Remove items from the shelf above the light shield. Remove the shelf. Use both hands to grasp each end of the light shield. Press in on the bottom of the shield with your thumbs while rotating the cover up and out. Replace the bulb with an appliance bulb of the same or lower wattage. Replace the shield by engaging the bottom tab into the slot and applying light forward pressure until the shield snaps in place. Set the master power switch to the I (on) position and close the grille panel. Freezer Compartment Raise the grille panel, set the master power switch to the O (off) position and allow lamps to cool. Remove the items from the shelf just below the light shield. Remove the shelf. To remove the light shield, press down on the top of the shield and pull the tabs out of the slots. Tilt the shield forward and out. Replace the bulb with an appliance bulb of the same or lower wattage, and reinstall the light shield. Replace the shield by engaging the bottom tab into the slot and applying light forward pressure until the shield snaps in place. Set the master power switch to the I (on) position and close the grille panel. Dispenser Raise the grille panel, set the master power switch to the O (off) position and allow lamps to cool. The bulb is located in the dispenser under the control panel. Remove the two screws from the light shield. Slide the light shield toward the dispenser to disengage the tabs, then remove the light shield. Remove the light bulb by turning it counterclockwise. Replace the bulb with a bulb of the same size and wattage. Replace the light shield by sliding the tabs into the slots in the front of the dispenser. Replace the two screws. Set the master power switch to the I (on) position and close the grille panel. Consumer Support 14