Electrolux E42BS75EPS Owners Guide - Page 35

Installation Instructions 12 CONNECT WATER SUPPLY Check to make sure that Master Power switch is in the O (OFF) position. Refrigerator Water Supply House Water Supply • Locate and bring tubing to the front of the cabinet. • Turn the water on to flush debris from line. Run about a quart of water through tubing into a bucket, then shut off water. Copper Tubing • Slip a 1/4″ nut and ferrule onto end of copper tubing. Insert tube into the union fitting on the unit and tighten nut to union. • Turn on the water to check for leaks. Note: Make sure excess tubing length does not interfere with toekick installation. 13 TURN ON THE POWER • Set the Master Power switch to the I (ON) position. • Check to make sure power to refrigerator is on by opening refrigerator door to see if interior lights are on. Raise Grille Panel Master Power Switch • The temperature controls are preset at 37° for the Fresh Food section and 0° for the Freezer section. • Allow 24 hours to stabilize before making adjustments. • Dispense water for 2 minutes to remove trapped air from the water system. 35