Electrolux E42BS75EPS Owners Guide - Page 32

Installation Instructions 8 SECURE REFRIGERATOR TO CABINETS Whenever possible, perform this step for anti-tip security. The refrigerator must be secured to prevent tipping. • Raise the grille panel to access case trim. • Drive a screw through the trim and into the adjacent cabinet using holes provided. • Follow the same procedure on the opposite side. Raise Grille Panel to Stop Position Drive Screws Through Case Trim Into Adjacent Cabinets 9 ADJUST DOOR SWING NOTE: This refrigerator has a 2-position door stop. When space does not allow the door to swing open fully to 130°, you may change the door swing to a 90° opening. SKIP THIS STEP IF DOOR OPENING IS SATISFACTORY FOR YOUR INSTALLATION SITUATION. • Open the door to view the bottom hinge. Note the door stop pin location. The pin is factory installed in the 130° position. • Partially close the door. From above, use a flat-head screwdriver to unscrew the door stop pin and reinstall into the 90° position. 10 INSTALL GRILLE PANEL • Raise the grille panel to the stop position. Raise Grille Panel • Remove 4 screws on bottom trim; retain all screws. • Remove bottom trim. • NOTE: Stainless steel and acrylic panels are covered with a protective film. Remove the film before installing the panel. • Slide panel over the metal backer panel and under the trim. • If necessary, tap with a wood block until panel slips under the top trim piece. • Reassemble bottom trim. Tighten screws. Interior 90° Door 130° Hinge 32