Electrolux E42BS75EPS Owners Guide - Page 31
Level Refrigerator, Connect Power, Move Into, Installation Space
UPC - 012505691669
View all Electrolux E42BS75EPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Installation Instructions 5 CONNECT POWER • Connect refrigerator power cord plug to a properly grounded receptacle. Set the Master Power switch to the I (ON) position. Raise Grille Panel Master Power Switch • Check to make sure power to refrigerator is on by opening refrigerator door to see if interior lights are on. CAUTION: • After power has been established, turn the Master Power switch to the O (OFF) position. 6 MOVE INTO INSTALLATION SPACE • Slide the unit into the installation space. • Place excess slack in the power cord on top of the refrigerator. • Use care to ensure the power cord is not pinched behind the unit. Height from Floor to Bottom of Wood Block 82" 7 LEVEL REFRIGERATOR All models have 4-point leveling. The front and back are supported by leveling legs. Both are accessible from the front of the refrigerator. • To level the back of the refrigerator, turn the 1/2″ hex nut located above the front wheels. Turn clockwise to raise or counterclockwise to lower the refrigerator. • For front leveling, use a 7/16″ open-end wrench. • Adjust height of refrigerator to match installation cutout opening 83-1/2″ to 84-1/2″. The refrigerator should be level and plumb with cabinets. Leveling Leg Hex Nut Adjusts Rear Leveling Legs IMPORTANT NOTE: The refrigerator must be level. If it is not, the doors may not align evenly at the top. See Step 16. CAUTION: The rear leveling legs and front leveling legs are limited to a maximum height adjustment of 1″. If the installation requires more than 84-1/2″ height, the installer should elevate the refrigerator on a sheet of plywood or runners. Cabinet trim could be added across the top of the opening to shorten the opening. If you attempt to raise the refrigerator more than 1″, you will damage the front and rear leveling legs. 31