Electrolux EI30MH55GB Service Manual - Page 23

PROCEDURE LETTER TEST PROCEDURES COMPONENT TEST EI30MH55GSA EI30MH55GBA EI30MH55GWA (9) Reconnect the oven to the power supply and check the sensor cook operation as follows: 9-1. Fill approximately 200 milliliters (7.2 oz) of tap water in a 1000 milliliter measuring cup. 9-2. Place the container on the center of tray in the oven cavity. 9-3. Close the door. 9-4. Touch the TIMER/CLOCK pad once, the POWER LEVEL pad twice, the START pad once, the number pad 1 once and the number pad 4 once. 9-5. The control panel is in automatic Sensor operation. 9-6. The oven turns off automatically, and the time for detecting moisture will be displayed. If new sensor dose not operate properly, the problem is with the control unit, and refer to explanation below. CHECKING CONTROL UNIT (1) Disconnect the power supply cord, and then remove outer case. Refer to procedure of "HOOD LOUVER REMOVAL", "REMOVAL OF OVEN FROM WAL " and "OUTER CASE REMOVAL". (2) Open the door and block it open. (3) To discharge high voltage capacitor, waite for 60 seconds. (4) Disconnect the sensor connector that is mounted to control panel. (5) Then connect the dummy resistor circuit (see fig.) to the sensor connector of control panel. (6) Disconnect the leads to the primary of the inverter unit. (7) Ensure that these leads remain isolated from other components and oven chassis by using insulation tape. (8) After that procedure, re-connect the power supply cord. (9) Check the sensor cook operation proceed as follows: 9-1. Touch the TIMER/CLOCK pad once, the POWER LEVEL pad twice, the START pad once and the number pad 1 once and the number pad 4 once. 9-2. The control panel is in the sensor cooking operation. 9-3. After approximately 65 seconds, push plunger of select switch for more than 3 seconds. This condition is same as judgement by humidity sensor. 9-4. After approximately 3 seconds, the display shows " X X . X X " which is the time for detecting moisture. If the above is not the case, the control unit is probably defective. If the above is proper, the humidity sensor is probably defective. (10) Disconnect the power supply cord, and then remove outer case. (11) Open the door and block it open. (12) To discharge high voltage capacitor, waite for 60 seconds. (13) Disconnect the dummy resistor circuit from the sensor connector of control panel. (14) Carry out necessary repair. (15) Reconnect all leads removed from components during testing and repairing. (16) Re-install the outer case (cabinet). (17) Reconnect the power supply cord after the outer case is installed. Run the oven and check all functions. (18) Carry out "Water load cooking test" again and ensure that the oven works properly. R1, R2 : 22Ω ± 1% 1/2W R3 : 4.3Ω ± 5% 1/4W R4 : 1MΩ ± 5% 1/4W Plunger NC NO To connector (F) on Control Unit. 1 F-1 2 F-2 3 F-3 CONNECTOR R1 R2 R3 R4 COM COM NO NC Sensor Dummy Resistor Circuit 23