Electrolux EI30MH55GB Service Manual - Page 37
Humidity Sensor Removal, Table Tray Assembly, Noise Filter Removal - vacuum
UPC - 012505558610
View all Electrolux EI30MH55GB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
HUMIDITY SENSOR REMOVAL 1. Disconnect the power supply cord, remove the oven EI30MH55GSA EI30MH55GBA EI30MH55GWA from wall, and remove outer case. (Refer to procedure of "Removal of Oven from Wall" and "Outer Case Removal".) And proceed as follows. of the humidity sensor should be positioned through the hole of the oven cavity top plate (right). 2. Open the door and block it open. 3. To discharge the high voltage capacitor, wait for 60 seconds. Sensor ground wire Screws Humidity sensor Hole 4. Remove seven (7) screws holding the hood intake duct R to the oven cavity top plate, the oven cavity front flange, Screw Wire lead of humidity sensor fan duct, base plate R, and magnetron duct. And remove the hood intake duct R. 5. Disconnect the connector CN-F of humidity sensor from Hood duct L Hole the control unit. 6. Remove the two (2) screws and one (1) washer holding the humidity sensor to the hood duct L. Hood duct R 7. Release the wire lead of humidity sensor from the holes of the hood ducts L and R. Hole Wire tie 8. Now, the humidity sensor is free. NOTE: When the humidity sensor is reinstalled, the wire tie This illustration is under the condition which hood intake duct R is removed NOISE FILTER REMOVAL 1. Disconnect the power supply cord and then remove outer case. 2. Open the door and block it open. 3. Discharge high voltage capacitor. 4. Disconnect the wire leads from the terminals of the noise filter . 5. Remove one (1) screw mounted into the noise filter and chassis support. 6. Now the noise filter is free TABLE TRAY ASSEMBLY Removal 1. Open the door and block it open. 2. Insert a putty knife into the gap between the table tray assembly and the oven cavity front plate. And lift up the front edge of the table tray assembly. 3. Remove the table tray assembly from the oven cavity. 4. Now, the table tray assembly is free. faces front. And place the table tray assembly into the oven cavity. 5. At first, insert the front edge of the table tray assembly into the oven cavity. And then push the rear edge of the table tray assembly. Table tray assembly UPSIDE Table tray assembly Front edge Putty knife Oven cavity Table Tray assembly removal Reinstallation 1. Remove the two (2) stirrer fans. 2. Clean the oven cavity bottom plate and /or under the antenna plate assembly by a vacuum cleaner. 3. Reinstall the two (2) stirrer fans to the stirrer shafts. 4. Make sure that the flat edge of the table tray assembly 37 Flat FRONT SIDE Flat Oven cavity Rear edge Push Front edge Table tray assembly Table Tray assembly installation