Electrolux EI30MH55GB Service Manual - Page 35

metal pieces may be produced. * Do not touch the pliers to the coil of the fan motor because the coil may be cut or damaged. * Do not disfigure the bracket by touching with the pliers. 2. Remove the fan blade from the shaft of the fan motor by pulling and rotating the fan blade with your hand. 3. Now, the fan blade will be free. CAUTION: * Do not reuse the removed fan blade because the hole (for shaft) may be larger than normal. Coil Groove joint pliers EI30MH55GSA EI30MH55GBA EI30MH55GWA METHOD FOR INSTALLING FAN BALDE 1. Hold the center of the bracket which supports the shaft of the fan motor on the flat table. 2. Install the fan blade to the shaft of fan motor by pushing the fan blade with a small, light weight, ball peen hammer or rubber mallet. CAUTION: * Do not hit the fan blade with excesive force when installing because the bracket may be disfigured. * Make sure that the fan blade rotates smooth after installation. * Make sure that the axis of the shaft is not slanted. Shaft Stator Gap Bracket Rotor Rear View Shaft Axis Stator Rotor These are the positions that should be pinched with pliers. Side View Table Center of bracket STIRRER MOTORS REPLACEMENT Removal 1. Disconnect the power supply cord. 10.Now, the stirrer motor (right one) is free. 2. Open the door and block it open. 3. To discharge the high voltage capacitor, wait for 60 seconds. 4. Remove the five (5) screws holding the bottom sash to the base cover. 5. Remove the three (3) screws holding the base cover to the oven cavity front face plate. 6. Open the base cover. Stirrer motor (left one) 7. Disconnect the wire leads from the stirrer motor (left one). 8. Remove the two (2) screws holding the stirrer motor to the oven cavity. 9. Now, the stirrer motor (left one) is free. Reinstallation 1. Insert a putty knife into the gap between the table tray assembly and the oven cavity front plate. And remove the table tray assembly from the oven cavity. 2. Install the stirrer motor (left one) to the oven cavity with the two (2) screws. 3. Reconnect the wire lead to the stirrer motor (left one), referring to the pictorial diagram. 4. Make sure that the stirrer motor gear, stirrer shaft assembly and shield spring are installed to the motor mounting angle. 5. Install the stirrer motor (right one) to the motor mounting angle with the two (2) screws. 6. Install the motor mounting angle to the oven cavity with Stirrer motor (right one) the two (2) screws. 7. Disconnect the wire leads from the stirrer motor (right 7. Reconnect the wire leads to the stirrer motor (right one), one). referring to the pictorial diagram. 8. Remove the two (2) screws holding the motor mounting 8. Reinstall the two (2) stirrer fans to the two (2) stirrer angle to the oven cavity. shafts. 9. Remove the two (2) screws holding the stirrer motor to 9. Reinstall the table tray assembly to the oven cavity. the motor mounting angle. STIRRER FAN ASSEMBLY INSTALLATION UPSIDE 1. Make sure that the stirrer fan faces upside, as shown in the following figure. The upside of the stirrer fan is engraved with the part number. B014 2. Install the three stirrer spacers to the stirrer fan, as shown UPSIDE in the following figure. 3. Install the stirrer fan to the stirrer shaft. Parts number Stirrer fan Stirrer spacer Stirrer fan assembly 35