Electrolux EIGD55IKG Installation Instructions - Page 14
Explosion, Hazard
UPC - 012505379710
View all Electrolux EIGD55IKG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
'"l installation instructions 1. Remove the shipping cap from gas pipe at the rear of the dryer. . Open the shutoff valve in the gas supply line to allow gas to flow through the pipe. Wait a few minutes for gas to move through the gas line. DO NOT connect the dryer to LR gas service without converting the gas valve. An LR conversion kit must be installed by a qualified gas technician. . Connect a 1/2 inch (1.27 cm) I.D. semi-rigid or approved pipe from gas supply line to the 3/8 inch (0.96 cm) pipe located on the back of the dryer. Use a 1/2 inch to 3/8 inch (1.27 cm to 0.96 cm) reducer for the connection. Apply an approved thread sealer that is resistant to the corrosive action of liquefied gases on all pipe connections. Manual Shutoff Valve Flare Union GAS FLOW _ Flare Union Shutoff ValveOpen position 4, Check for gas system leaks with a manometer. If a manometer is not available, test all connections by brushing on a soapy water solution. :losed _ J ,._ Nipple Open Flexible Connector l Inlet Pipeon Back of Dryer All connections racistbe wrench-tightened " "- d',,, Z ,_[i _rj'_¢ EXPLOSION HAZARD NEVER test for gas leaks with an open flame. ;,,,_if,, L L The supply line must be equipped with an approved manual shutoff valve. Th_s valve should be located in the same room as the dryer and should be in a location that allows ease of opening and closing. Do not block access to the gas shutoff valve.