Electrolux EIGD55IKG Installation Instructions - Page 19
ELECTRICAL, SHOCK, HAZARD, A Removing, Trim Ring, B Removing, Front, Panel
UPC - 012505379710
View all Electrolux EIGD55IKG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Reversing Door I 1 Be sure you have adequate swing area before reversing door. 2 You will need a screw driver with a #2 square bit. 3 Protect flat work surface, such as top of dryer or floor near dryer, with a soft cloth or towel. 4 Be sure dryer is unplugged from power source! ELECTRICAL SHOCK HAZARD Failure to disconnect power source before serwcing could result in personal injury or even death. Tools needed: _i_,_-\ //'_'_\ 1'___) ___j-/ Screwdrwers with #2 square & straight bit A) Removing Trim Ring 1 Open door to 90 degree angle. 2 Remove and save trim plug and long, course-thread, panhead screw, B) Removing Door from Front Panel 1 Reopen door to 90 degree angle. 2 Remove 2 short, course-thread, panhead screws. 3 Close door. 4 Rotate door trim approximately _A"counter- clockwise and pull ring away from door. E:3 ;" 3 While supporting door with the other hand, remove 3 short, fine-thread, counter-sunk sc rew s. /" _ ,/" 'k\ 4 Gently place door face down on flat, covered work surface.