Electrolux EIGD55IKG Installation Instructions - Page 16

installation instructions . If your installation has room for the COLD water supply to accept the "Y" connector directly, thread the "Y" connector to the COLD water supply and snug it by hand; then tighten it another 2/3 turn with pliers. ,-_ _, , DIRECT CONNECTION OR WITH EXTENSION If you were able to install the "Y" connector directly to the COLD water supply, please skip to step 8. 2. If there is not room to install the "Y" connector directly, thread the short extension hose on to the COLD water supply and snug it by hand; then tighten it another 2/3 turn with pliers. 3. Thread the "Y" connector to the short extension hose and snug it by hand; then tighten it another 2/3 turn with pliers. 4. Connect the COLD inlet hose for the washer to the "Y" connector and snug it by hand; then tighten it another 2/3 turn with pliers. 5. Connect the straight end of the long hose from the kit to the other outlet on the "Y" connector and snug it by hand. Connect the hose's 90 ° coupling to the brass water inlet on the back of the dryer and snug it by hand. Tighten each connection of the dryer inlet hose another 2/3 turn with pliers. 6. Turn on the water and check for leaks at all connections. ;.)_ __ COLD WATER SUPPLY HOSE TO VVASHER ER INLE RYEF