Epson 2000P Printer Basics - Page 39

After you finish your printout, you can leave the paper in place and start another print job immediately after it. If you wish to make a dividing line between print jobs, press the E load/eject button. The printer prints a small line on the roll paper to show you where to cut it and feeds the paper forward. Press the E load/eject button again; the paper automatically moves back into the correct position before printing. If you're done printing, follow the steps in the next section to remove and store the roll paper. Removing and Storing Roll Paper After you finish printing, you need to cut off your printout from the rest of the roll and remove the roll paper from the printer. Follow these steps: 1. Press the E load/eject button. The printer prints a small line on the roll paper to show you where to cut it and feeds the paper forward. 2. Cut the roll paper, using the line as a guide. Don't cut inside the line closer to the printer. Don't pull on the paper as you cut it; you may damage your printout. Load/eject button 3. If you want to continue printing on the roll paper, press the E load/eject button again; the paper automatically moves back into the correct position before printing. If you've finished printing on the roll paper, hold down the E load/eject button for about three seconds. The roll paper feeds backward so you can remove it from the printer. (You may need to repeat this step to back it all the way out.) After you finish printing, remove the roll paper from the printer and return the unused paper to its original package. Store or display your printouts by following the guidelines in "Taking Care of Your Prints" on page 25. Keep unused paper, as well as your printouts, away from high temperatures and humidity and out of direct sunlight. 34