Epson ActionPrinter 4500 User Manual - Page 214

Printing Problem The print position is not what you expected (continued). Page length does not match the length of the paper. Regular gaps occur in the printout. Skip over perforation is set, but the perforation does not fall in the center of the skip. Solution Check the page length set by your application software and adjust it if necessary, or change the page length setting with DIP switch 2-1. If you are using the cut sheet feeder, the self test function prints the number of printable lines that can fit on a single sheet. Use this feature to determine the correct page length setting. See Chapter 3. One-inch skip over perforation may be set. Set DIP switch 2-3 to off, or use your application program to cancel skip over perforation. See Chapter 3. The loading position of the paper may be too high or too low. Use the microadjustment feature to reset the loading position so that the perforation is centered within the skip area. Your application program may be setting the top and bottom margins. If this is the case, turn off skip over perforation by setting DIP switch 2-3 to off. The page length for continuous paper may be set incorrectly. Set DIP switch 2-1 to 11 or 12 inches. See Chapter 3. 7-12 Troubleshooting