Epson BrightLink 1480Fi Installation Guide - Page 67
Installing the Touch Unit
View all Epson BrightLink 1480Fi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
English 8 Installing the Touch Unit Before installing the touch unit, make sure you install the projector and adjust the projected image (see page 43). You also need to calibrate the interactive pen(s) before you install the touch unit (see the online User's Guide for more information). The touch unit is included with the BrightLink 1485Fi/1485Fi+. You can purchase it as an optional accessory for the BrightLink 1480Fi/1480Fi+/EB-725Wi/EB-735Fi. The steps for installing the touch unit vary depending on where you are installing the touch unit: • If you are installing the touch unit on a whiteboard, see "Installing the touch unit on a whiteboard" on page 68. • If you are installing the touch unit above the frame of a whiteboard (requires the optional touch unit bracket), see "Installing the touch unit above a whiteboard" on page 80. To achieve the best touch performance it is highly recommended that you install the touch unit directly on the whiteboard. ❏ If the distance from the wall to the surface of the whiteboard is greater than 2 inches (51 mm), you must install the touch unit on the whiteboard. ❏ If the frame of the whiteboard extends more than 0.1 inch (3 mm) away from the board surface, you must install the touch unit on the whiteboard. 2 inches (51 mm) 0.1 inch (3 mm) Caution The touch unit should only be connected to the BrightLink 1480Fi/1480Fi+/1485Fi/1485Fi+/ EB-725Wi/EB-735Fi models. Do not connect the touch unit to any other projectors or devices. 67