Epson C31C636834 Technical Reference - Page 31
Rev. A, Setup, TM-T88IV Technical Reference Guide, The adjustment screw is set to the lower position
View all Epson C31C636834 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
TM-T88IV Technical Reference Guide 2. Loosen the adjustment screw fastening the detector, and align the upper edge of the positioning plate with the adjustment position. Adjustment positions are as follows: Adjustment position Upper Lower Remaining amount of roll paper (outer diameter: mm) Approx. 27 Approx. 23 Adjustment screw Positioning plate Detection lever Figure 2-10 NE detector positions Note: The adjustment screw is set to the lower position before shipment. 3. Tighten the adjustment screw. 4. After adjustment, make sure that the detection lever operates smoothly. 5. Load the roll paper. 6. Close the roll paper cover. Rev. A Setup 2-7
Rev. A
Setup
2-7
TM-T88IV Technical Reference Guide
2.
Loosen the adjustment screw fastening the detector, and align the upper edge of the
positioning plate with the adjustment position. Adjustment positions are as follows:
Figure 2-10
NE detector positions
Note:
The adjustment screw is set to the lower position before shipment.
3.
Tighten the adjustment screw.
4.
After adjustment, make sure that the detection lever operates smoothly.
5.
Load the roll paper.
6.
Close the roll paper cover.
Adjustment
position
Remaining amount of roll
paper (outer diameter: mm)
Upper
Approx. 27
Lower
Approx. 23
Detection lever
Positioning plate
Adjustment screw