Epson ColorWorks C3500 Technical Reference Guide - Page 171

Chapter 3 Handling Fanfold paper The following media is supported: • Continuous paper (Blackmark) • Die-cut label (Blackmark) Premise • Moving to the peel position as post-printing processing is not selected. • For Continuous paper (Blackmark) and Die-cut label (Blackmark), Enable "Notification setting at media size error".  Go to [Printer Utilities] - [Printer Preferences] - [Advanced Settings] - [Notification Settings], then from the [Notification Setting at a Media Size Error] menu, select [Notify errors]. Method for arranging the media Ensure a margin of 107.5 mm {4.32"} or more from the rear edge of the last ticket or label to be printed, and for labels, leave only the backing. Also, behind the last ticket or label to be printed, place a black mark [A in the figure] at the same interval up until that point [L in the figure], leave a gap of 5 ± 0.5 mm {0.20 ± 0.02"} mm behind that, and place another black mark [B in the figure]. 3 The maximum interval between the aforementioned 2 black marks is 11 mm {0.43"}. Paper feed direction L. L. Maximum 11 mm {0.43" } 5±0.5 mm {0.20±0.02" } Rear edge of the last ticket black mark Continuous paper (Blackmark) 107.5 mm {4.32" } or more Roll core Paper feed direction L. L. Maximum 11 mm {0.43" } 5±0.5 mm {0.20±0.02" } Rear edge of the last ticket black mark Die-cut label (Blackmark) 107.5 mm {4.32" } or more Roll core Once the printing processing (including autocutting) for the last ticket or label is completed properly, directly after the new print data is sent to the printer, a "Media size error" occurs, and the printer stops with the print data saved. 171