Epson FX-286e User Manual - Page 76
ESC EM, Turn Automatic Sheet Feed Mode On/Off, Format, Comments, MSB control, ESC = equal
View all Epson FX-286e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
ESC EM Turn Automatic Sheet Feed Mode On/Off Format: ASCII code: ESC EM n Decimal: 27 25 n Hexadecimal: 1B 19 n Comments: The following values can be used for n: 4: Mode is turned ON. 0: Mode is turned OFF. The variables are the characters "0" (48 decimal or 30 hex) and "4" (52 decimal or 34 hex). Do not use 1 decimal, 01 hex, 4 decimal, or 04 hex. The command should not be used unless the automatic sheet feeder is installed. It is ignored if any value other than "0" or "4" is used for n. The command overrides the setting of DIP switch 2-2. MSB control Note: MSB is the Most Significant Bit. MSB control (ESC = , ESC >, and ESC #) is not valid for graphics or user-defined characters. ESC = (equal) Set MSB to 0 Format: ASCII code: ESC = Decimal: 27 61 Hexadecimal: 1B 3D Comments: Sets the MSB of all incoming data to 0. Some computers always send data with the MSB set to 1, which means that italics or character graphics will always be printed. ESC = can overcome this problem. A-10 Command Summary