Epson GT-2500 Plus Product Information Guide - Page 3

Epson GT-2500 and GT-2500 Plus Loading Documents in the Automatic Document Feeder You can load up to 50 sheets of paper in the ADF (a stack thickness of 0.2 inches [5.0 mm] or less). See "Document Specifications" to the right for details. Only load sheets that are all the same size. Caution: Do not feed photographs or valuable original artwork into the ADF. Misfeeding may wrinkle or damage the original. Scan high-quality color or halftone documents on the document table instead. Remove any documents from the document table and make sure there is no dust on the glass before loading documents in the ADF. 1. Extend the paper support at the end of the output tray on the ADF. 2. Slide the edge guides on the input tray of the ADF all the way outward. 3. Place your document in the input tray with the printed side facing up and the top edge facing into the feeder. Slide the paper into the feeder until it meets resistance. Then slide the edge guides over to the edge of the paper. Document Specifications The table below listed the sizes of paper you can load in the ADF. Paper name Letter A4 Legal B5 A5 Size 8.5 × 11 inches (215.9 × 279.4 mm) 8.3 × 11.7 inches (210 × 297 mm) 8.5 × 14 inches (215.9 × 355.6 mm) 7.2 × 10.1 inches (182 × 257 mm) 5.9 × 8.3 inches (148.5 × 210 mm) Load only documents that meet the following specifications in the ADF: Size Weight Paper type Width: 5.9 to 8.5 inches (148.5 to 215.9 mm) Length: 5.9 to 14 inches (148.5 to 355.6 mm) 60 to 105 g/m2 High-quality bond paper Make sure your documents meet the following conditions before loading them into the ADF: ❏ The ink is dry. ❏ The document has no holes and is not ripped or wrinkled. ❏ The document has no staples, paper clips, or other objects attached to it; these may damage the feeder mechanism. ❏ The document has no folds. ❏ The document has no cut-out areas. ❏ The document is not a multipart form or bound. ❏ The document has no rear carbon coating. 7/06 Epson GT-2500 and GT-2500 Plus - 3