Epson LQ 1050 Technical Manual - Page 135
Plunger Removal
View all Epson LQ 1050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
REV.-A 4.2.5.9 Plunger Removal Step 1: Remove the printer mechanism. Step 2: Remove the RE (3), and disconnect loading lever of the plunger from the paper holding lever L. Step 3: Remove two CPS (0)(3 X 6) screws, which secure the plunger to the side frame L, then remove the plunger. ., i-- - Plu;ger Loading Lever Figure 4-28. Plunger Removal ASSEMBLY POINTS 1. Mount plunger on side frame L by tightening the two CPS (0) (3 X 6) screws lightly. 2. Set loading lever onto paper holding lever L, and put on RE (3). 3. Hold the pulnger and cylinder as shown in Figure 4-29, and position it where move smoothly the cylinder, and tight screws. f-.'"' Figure 4-29. Plunger Positioning 4-22
REV.-A
4.2.5.9 Plunger
Step 1: Remove
Step 2: Remove
L.
Removal
the printer mechanism.
the RE (3), and disconnect
Step 3: Remove two
CPS
(0)(3
X
6) screws,
loading lever of the plunger from the paper holding lever
which secure the plunger
to the side frame L, then remove
the plunger.
.,
i
--
Plu;ger
Loading Lever
—
Figure 4-28. Plunger Removal
ASSEMBLY POINTS
1. Mount plunger on side frame L by tightening the two
CPS
(0) (3 X 6) screws lightly.
2. Set loading lever onto paper holding lever L, and put on RE (3).
3. Hold the
pulnger
and cylinder as shown in Figure 4-29, and position it where move smoothly the
cylinder, and tight screws.
Figure 4-29. Plunger Positioning
f
‘“’
-.
4-22