Epson PowerLite 50c Product Information Guide - Page 6

EPSON Powerlite 50c/70c t Depending on your computer's video card, you might need to use the Display utility in the Control Panel to make sure that both the LCD screen and external monitor port are enabled. See your computer's documentation or online help for details. t Check your computer's video resolution and scan frequency to see if they are supported, as listed on page 3. You may need to adjust your computer's resolution and scan frequency to match one of the modes listed. Focusing Your Image Rotate the focus ring to sharpen the image. focus ring Using the E-Zoom Button If you want to zoom in on a portion of the image, use the E-Zoom and Enter buttons on the remote control. Press the + side of the E-Zoom button to zoom into your image in small increments. Press the - side to zoom out. To position the zoomed image on the screen, press the top, bottom, left, or right side of the Enter button on the remote control. (Press Esc to return your image to its original size and turn off E-Zoom.) E-Zoom button Enter button top + Zoom in left right - Zoom out Note: If the image from your computer is still out of focus, you can increase the clarity by pressing the Auto button on the remote control. This optimizes the projector's tracking, sync, and position settings. (You can also adjust these settings using the projector menus.) Adjusting the Image Size You can adjust your image size using the Wide/Tele button on the projector or zoom into a portion of the image using the E-Zoom button on the remote control. Using the Wide/Tele Button To enlarge or reduce your image size in small increments, use the Wide/Tele button on the projector. Press the T side of the button to reduce the image size, or the W side of the Wide/ Tele button to enlarge the image to full size. Wide/Tele button Enlarge WT Reduce WT Note: You can always move the projector closer to or farther from the screen to adjust the image size. bottom Adjusting the Image Height If your image is too low, you can raise it by extending the projector's feet. 1. Stand behind the projector. Pull up the blue foot release levers and lift the front of the projector. This unlocks the feet. 2. Raise or lower the front of the projector as necessary. Caution To avoid damaging the lens, do not lift the projector by the lens. 3. Once the image is positioned where you want it, release the levers to lock the feet into position. 4. To fine-tune the height, rotate the feet clockwise to raise the projector and counterclockwise to lower it. 6 - EPSON Powerlite 50c/70c 01/01