Epson TM-L90 Plus with Peeler Technical Reference Guide - Page 136
Appendix, The values in the above table are based on use of Epson specified paper.
![]() |
View all Epson TM-L90 Plus with Peeler manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
TM-L90 Peeler Model Life Labels Receipts MTBF MCBF Thermal head Vibration resistance Impact resistance Acoustic noise (operating) Issues 1,000,000 labels (With feed direction label length of 25.4 {1 inch} to 63.5 mm {2.5 inch}. Equivalent to a travel distance of about 30 to 70 km. When printing labels in excess of 63.5 mm, product lifetime in number of labels comes after a travel distance of 70 km) 20,000,000 lines printed (with 1 line at 3.75 mm) (Assuming repeated printing of 10 lines with paper thickness of 75 µm or less and 15 line feed. Equivalent to a travel distance of about 120 km) 150 million pulses 360,000 hours (Using receipts during the product lifetime. Failure means random failure in the random failure period) 70,000,000 lines printed (Using receipts during the product lifetime. Indicates the overall mean time between failures including wear-out failure and random failure up to product lifetime of 20 million lines printed) When packed: Frequency: 5 to 55 Hz Acceleration: Approximately 19.6 m/s2 {2 G} Sweep: 10 minutes (half cycle) Duration: 1 hour Directions: x, y, and z No external or internal damage should be found after the vibration test, and the unit should operate normally. When packed: Package: Epson standard package Height: 60 cm {23.62"} Directions: 1 corner, 3 edges, and 6 surfaces No external or internal damage should be found after the drop test, and the unit should operate normally. When unpacked:Height: 5 cm {1.97"} Directions: Lift one edge and release it (for all 4 edges). When the printer is not printing, no external or internal damage should be found after the drop test. Approximately 53 dB (ANSI bystander position) NOTE: The value as shown above is measured when the Epson evaluation printing pattern is used. This value may be different, depending on the paper to be printed, the print duty, or the print conditions, such as the print speed or the print density. The values in the above table are based on use of Epson specified paper. Depending on the paper, paper dust and adhesive may stick to the platen, head, and peeler unit. 136 Appendix
![](/manual_guide/products/epson-tml90-plus-peeler-technical-reference-guide-e4988ec/136.png)