Epson TM-L90 Plus with Peeler Technical Reference Guide - Page 46
Msw5 only for 4** models, Msw7 only for 4** models
View all Epson TM-L90 Plus with Peeler manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Msw5 (only for 4** models) Msw Function 5-1 USB power-saving function 5-2 Recovery conditions from receive buffer BUSY 5-3 Paper sensor to output paper end signals 5-4 Error signal output 5-5 (Reserved) to 5-8 Initial Msw Setting Msw Setting Off On setting utility Mode Enabled Disabled Off ✓ ✓ 256 bytes free 138 bytes free Off ✓ ✓ Enabled both Roll paper end sensor and Roll paper nearend sensor Disabled Off ✓ Enabled Disabled Off ✓ ✓ - - Off [Msw5-1]: Valid only when the USB interface communication condition of the built-in USB is set to the Vendordefined class and the system configuration is set so that the USB driver can support the USB power-saving function. [Msw5-2]: Valid only when the receive buffer capacity is 4K bytes. [Msw5-4]: Valid only for parallel interface Msw7 (only for 4** models) Msw Function Initial Msw Setting Msw Setting Off On setting utility Mode 7-1 Printer operation when print Print starting Print starting Off ✓ ✓ position misalignment is position is not position is detected changed adjusted (*1) 7-2 Printer operation in recovery Automatic Paper feed to Off ✓ ✓ from paper layout error paper layout the next print measurement starting position (*2) 7-3 Autocut after closing cover Disabled Enabled (*3) Off ✓ ✓ 7-4 Paper feed length after closing 20 mm 40 mm Off ✓ ✓ cover 7-5 (Reserved) to 7-8 - - Off (*1) When using label paper or paper with black mark, if print position misalignment is detected during reverse feeding, the printer feeds the paper to the next print starting position. (*2) When [Msw8-2] is OFF and the printer recovers from a paper layout error, the printer feeds the paper to the next print starting position. (*3) When using paper without black mark (excluding label roll paper), when the roll paper cover is closed, the printer feeds the paper for the amount set with [Msw7-4], and cuts the paper. After the power is turned on, if printing is executed for the first time after a cut command is executed, the printer starts printing after executing reverse feeding to the print starting position. 46 Setup